Your production line could be hitting every operating target and still leaving throughput, yield, or margin on the table.
That’s because the settings that delivered your best results yesterday aren’t necessarily the right ones today.
A temperature that worked perfectly for one batch might use more energy than necessary on the next. A line speed that protected quality last week could be holding back production today.
When consistency comes at the cost of performance
Centerlining has long been an important part of manufacturing process improvement. By establishing standard operating settings for variables such as temperature, pressure, and speed, manufacturers reduce variation and make production more predictable.
It’s a proven approach to maintaining quality and consistency across shifts, operators, and production runs.
But a setpoint established under one set of operating conditions won’t necessarily deliver the same results under another.
Consider a drying process. Incoming material moisture varies between batches, affecting how much heat is needed to reach the required finished moisture level.
Keeping the same temperature target could mean wasted energy and over-drying on some batches, or under-dried product on others.
The same principle applies elsewhere:
- Line speed: In a building materials plant, changes in raw material moisture can affect how quickly material dries in a kiln. A fixed production speed may be unnecessarily slow when incoming material is drier, limiting output even when the kiln could handle more.
- Pressure: In tire manufacturing, variations in rubber compound properties can change how material flows through an extrusion die. Maintaining the same pressure target may no longer deliver the desired dimensions, potentially increasing scrap or rework.
What if operating targets adapted to the process?
Centerlining establishes how a process should run under defined conditions. Dynamic setpoints build on those standards by allowing operating targets to respond to what’s actually happening in production.
That’s where the difference between controllable and uncontrollable variables matters. Operators can’t change the moisture content of incoming raw materials or prevent equipment from aging. But they can adjust settings such as temperature or line speed to account for those differences.
Those adjustments need to balance competing production goals. Running faster might increase output but also create more defects. Higher temperatures might improve drying but increase energy costs.
The opportunity is to identify the operating settings that deliver the strongest results under current conditions, without compromising quality or safety.
Putting dynamic setpoints into practice
At Maple Leaf Foods, variations in raw materials affected slicing consistency, while conservative cooking settings limited yield.
Using Braincube’s Real-Time Process Optimization (RTPO), the manufacturer introduced flexible operating setpoints that are recalculated for each batch. Adjusting slicing settings to account for material differences helped reduce waste, while adapting cooking conditions helped improve yield without compromising food safety.
These adaptive setpoints contributed to a 12% yield improvement across multiple lines, with Maple Leaf Foods achieving ROI in just three months.
RTPO continuously evaluates live production data against historical performance to calculate and prescribe optimal operating setpoints. Operators receive clear, specific instructions on which settings to adjust, with prescriptions automatically recalculated as production conditions evolve.
Centerlining provides the standards for consistent production. RTPO takes those standards further by adjusting how the process should run based on actual operating conditions.
Find out what your fixed setpoints are costing you
How much value is being lost because your operating targets haven’t kept pace with your process?
Schedule a call with a Braincube expert to uncover where fixed operating targets are limiting performance and see how Real-Time Process Optimization can help you recover more value from the equipment you already have.